SECTION IIMATERIALSPart DProper ties MetricASME BPVC.II.D.M-20232023...
SECTION IIMATERIALSPart CSpecifications for Welding Rods,Electrodes, and...
SECTION IIMATERIALSASME BPVC.II.A-2023Part AFerrous Material...
Part AFerrous Material SpecificationsBeginning to SA-450SECTION...
STATEMENT OF POLICY ON THE USE OF THE ASME SINGLECERTIFICATION MARK AND...
TAPPI TIP0305-42 Folding Section standard by Technical Association of the Pulp and Paper Industry, 08/01/2007 Full Description What are the causes and remedies for folding sections of Flexo Folder Gluers Product Details...
TAPPI TIP0305-35 Rotary Diecutter Urethane Anvil Maintenance standard by Technical Association of the Pulp and Paper Industry, 08/01/2007 Full Description This technical information sheet presents some generally accepted suggestions, and the most common maintenance...
TAPPI TIP0305-33 Cleanup Procedures for Flexo Folder Gluer/Rotary Diecutters standard by Technical Association of the Pulp and Paper Industry, 08/01/2007 Full Description This technical information sheet has been written to provide general guidelines to the plant for...
TAPPI TIP 0404-28 Method for Evaluating Thickness of Wet Press Fabrics standard by Technical Association of the Pulp and Paper Industry, 05/22/2007 Full Description A method is described for measuring press fabric thickness using a hand-held caliper gauge. It is used...
TAPPI T 252 om-07 pH and Electrical Conductivity of Hot Water Extracts of Pulp, Paper and Paperboard standard by Technical Association of the Pulp and Paper Industry, 03/12/2007 Full Description This procedure provides for the extraction of pulp, paper, and paperboard...
TAPPI T449 om-07 Bacteriological Examination of Paper and Paperboard standard by Technical Association of the Pulp and Paper Industry, 03/12/2007 Full Description The following procedure is recommended for the bacteriological examination of paper and paperboard intended...
TAPPI T 418 cm-07 Organic Nitrogen in Paper and Paperboard standard by Technical Association of the Pulp and Paper Industry, 03/12/2007 Full Description This method is used for the determination of nitrogen from glue, casein, urea- and melamine-formaldehyde resins, amine...
TAPPI T281 sp-07 Open drum washer mat sampling technique standard by Technical Association of the Pulp and Paper Industry, 03/12/2007 Full Description This method is concerned with collecting pulp mat and liquor samples from open drum washers....
TAPPI T277 om-07 Macro Stickies Content in Pulp: the "Pick-up" Method standard by Technical Association of the Pulp and Paper Industry, 03/12/2007 Full Description This test method describes a procedure for determining heat-set area and number of macro stickies...
TAPPI T 520 cm-07 Curl of Gummed Flat Paper standard by Technical Association of the Pulp and Paper Industry, 2007 Full Description This method describes a procedure for determining the degree of curl developed by a remoistenable gummed sheet when it is exposed to...
TAPPI T 211 om-07 Ash in Wood, Pulp, Paper and Paperboard: Combustion at 525 Degrees C standard by Technical Association of the Pulp and Paper Industry, 01/01/2007 Full Description This method for determination of ash can be applied to all types and grades of wood pulp...
TAPPI T 204 cm-07 Solvent Extractives of Wood and Pulp standard by Technical Association of the Pulp and Paper Industry, 01/01/2007 Full Description This method describes a procedure for determining the amount of solvent-soluble, non-volatile material in wood and pulp....