CSA ANSI/IAS PRD 1-1998 Pressure Relief Devices for Natural Gas Vehicle (NGV) Fuel Containers

standard by CSA Group, 07/10/2000

Full Description

This is a searchable PDF.

1. INTRODUCTION

1.1

General. This standard has been developed to identify performance requirements for pressure relief devices for Natural Gas Vehicle (NGV) fuel containers. This standard sets minimum requirements for pressure relief devices produced for use on NGV fuel containers. NGV fuel containers comply with ANSI/IAS NGV2, Basic Requirements for Compressed Natural Gas Vehicle (NGV) Fuel Containers [4], FMVSS 304, Federal Motor Vehicle Safety Standards, 49 CFR Part 571.304, Compressed Natural Gas Fuel Con tainer Integrity [2], and/or CSA B51, Part 2, High Pressure Cylinders for On-Board Storage of Natural Gas as a Fuel for Automotive Vehicles [5], as appropriate. These fuel containers are intended only for the on-board storage of high pressure compressed natural gas as a fuel for automotive vehicles to which the containers are permanently attached. Regulations and standards which apply to fuel container installation and vehicle systems include FMVSS 303, Federal Motor Vehicle Safety Standards, 49 CFR Part 571.303, Fuel System Integrity of Compressed Natural Gas Vehicles [1], CS 301.2, Transport Canada/TC, Motor Vehicle Safety Regulations, Schedule IV, CNG Fuel Sys tem Integrity [3], NFPA 52, Compressed Natural Gas (CNG) Vehicular Fuel Systems [6], and B149.4, Natural Gas for Vehicles Installation Code [7].

1.2

Application. Natural Gas Vehicles use fuel containers categorized as follows:

Type 1 (NGV2-1 or CNG-1) Metal; Type 2 (NGV2-2 or CNG-2) Resin impregnated continuous filament with metal liner of prescribed strength; Type 3 (NGV2-3 or CNG-3) Resin impregnated continuous filament wi th metal liner; Type 4 (NGV2-4 or CNG-4) Resin impregnated continuous filament with a non-metallic liner ""full wrapped"".

These fuel containers may accidentally be exposed to fire or elevated temperature. These conditions may act to increase the contained pressure and/or to degrade the structural materials, depending on the container type and materials of construction. A pressure relief device (PRD) will provide a means to vent the fuel container under these conditions.

Product Details

Published: 07/10/2000 ANSI: ANSI Approved Number of Pages: 18 File Size: 1 file , 620 KB Product Code(s): 2413491, 2413491